Portable TV  (160-0165)           Operation            Faxback Doc. # 7819

1.  Extend the rod antenna.

2.  Set OFF/VHF/UHF/ to UHF.  The TV starts scanning and stops at the next
    active channel in the selected band.

3.  Press TUNING /\ or \/ to tune a different channel.  The tuning line on
    the screen aligns with the selected channel number to the right of the
    screen.

4.  Adjust VOLUME.

5.  Adjust the antenna for the best reception.

6.  Adjust BRIGHT for the desired brightness.  The brightness also changes
    with the screen's angle.

7.  Adjust TINT for the best color.

NOTES:  If desired, fold out the stand on the back of the TV, and lean the
        TV on a flat surface for a convenient viewing angle.

        If reception is poor, adjust the length or angle of the rod
        antenna.  If inside a metal or concrete building, moving closer to
        a window might improve reception.

BACKLIGHT

In low temperatures, the TV screen takes a few seconds to light, or it
might be slightly red in color.  This is not a malfunction.  Normal
operation resumes after a short while.

USING AN EARPHONE

You can mute the built-in speaker by connecting an optional earphone with
a 1/8-inch plug to the PHONE jack.

CAUTIONS:  Set VOLUME to the lowest setting before you begin listening. 
           Then, adjust the volume to a comfortable level.

           Do not wear the earphone while operating a motor vehicle or
           riding a bicycle.  This can cause a traffic hazard and is
           illegal in some areas.

(ALL-10/13/94)

Privacy Policy