Portable TV  (160-0122A)          Operation            Faxback Doc. # 7791

USING AN ANTENNA

You can use the built-in telescoping antenna in areas that have strong TV
signals.  For improved reception, connect the TV to a standard outdoor
VHF/UHF antenna.

If your outdoor antenna wire is 75-ohm coaxial cable, connect the cable to
the EXT ANT jack using a Female F to 1/8-inch Mini Plug adapter (Cat. No.
278-257).

If you use 300-ohm twin-lead for the antenna, use the supplied 75/300-ohm
adapter connect the wire to the TV as follows:

1.  Connect the wire from your outdoor antenna to the terminals on the
    side of the adapter.

2.  Flip down the TV's metal loop and insert the adapter's plug into the
    TV's EXT ANT jack.  This automatically disconnects the telescoping
    antenna.

WARNING:  Use extreme caution when you install or remove an antenna.  If
          the antenna starts to fall, let it go.  It count contact
          overhead powerlines and cause the electrocution and death of
          anyone touching it.  If it does hit a powerline, call the power
          company to remove the antenna.  DO NOT attempt it yourself.

USING THE PEDESTAL

You can use the supplied pedestal when you use AC or vehicle-battery
power.  The pedestal tilts to let you adjust the angle of the TV for
comfortable viewing.

1.  If the battery pack is connected to the TV, remove it.

2.  Align the small end of the pedestal base with the rails on the bottom
    of the TV and slide the pedestal into place.

3.  To disconnect the pedestal, hold it with the TV's screen facing you
    and slide the TV away from you.

USING THE CARRY CASE

The supplied carry case lets you carry the TV, the battery pack, and the
vehicle DC cord.  This case helps protect the TV when you are transporting
it and its accessories.

TUNING AND CONTROLLING THE PROGRAM

To operate the TV, choose and connect the power source.  Then, follow these
instructions.

1.  Rotate VOL to the left, toward ON.

2.  Set the VL/VH/UHF band switch to the desired setting.

                 Bands           Channels
                  VL               2-6
                  VH               7-13
                  UHF              14-69

3.  Rotate the TUNING control so that the arrow points to the desired
    channel in the selected band.

    To adjust the picture's brightness, rotate the BRIGHT control.

    To adjust the picture's contrast, rotate the CONT control.

    To stop the picture from rolling, rotate the V-HOLD control.

4.  Adjust the volume control for a comfortable listening level.

    To listen in privacy, insert a 1/8-inch plug of an earphone (not
    supplied) into the EAR jack on the back of the TV.

INTERFERENCE

Your TV might cause TV or radio interference even when it is operating
properly.  To determine whether your TV is causing the interference, turn
off the TV.  If the interference goes away, your TV is causing the
interference.  Try to eliminate the interference by:

    Moving your TV away from the receiver.

    Connecting your TV to an outlet that is on a different electrical
    circuit from the receiver.

    Contacting your local Radio Shack store for help.

If you cannot eliminate the interference, the FCC requires that you stop
using the device.

(ALL-10/10/94)

Privacy Policy