Video Stabilizer  (150-1270)       Features            Faxback Doc. # 7250

The ARCHER Video Enhancer/Stabilizer (VES) was developed by Radio Shack to
improve the overall performance of your home video system.

It may be used to improve the playback from a VCR or video disc player.
It may also be used to enhance recordings made from one VCR to another or
direct camera-to-VCR recordings.

                   Stabilizer - eliminates the shaky picture you sometimes
                                get when recording from a previously
                                recorded tape.

                     Enhancer - restores picture detail lost during
                                recording.  This is especially useful for
                                third generation tapes (copies made from
                                copies) or tapes made at slower recording
                                speeds.

  VNR (Video Noise Reduction) - reduces video noise ("snow" or graininess
                                in the picture).

               Automatic Fade - fades out picture and sound simultaneously
                                at the end of a recording.  Or fades in
                                picture and sound at the beginning of a
                                recording - just like the professionals.

          Audio Level Control - controls the audio signal level from the
                                TV VHF connector.  This lets you match the
                                audio level to your TV set.

             TV VHF Connector - provides access to an internal RF
                                modulator that converts the low frequency
                                audio/video signals used in VCRs, video
                                cameras, and video disc players to channel
                                3 or 4 on your TV.  Connect your TV to
                                this connector to monitor these signals
                                during recording or playback.

 Dual Audio/Video Input Jacks - allow connection of two input sources
                                (VCR), video disc player, or video camera)

Dual Audio/Video Output Jacks - allow you to record onto two VCRs from a
                                single VCR or camera.

                   A/B Switch - sends the signals from one pair of
                                audio/video input jacks to both pairs of
                                audio/video output jacks and to the TV VHF
                                jack.

               Channel Switch - selects channel (3 or 4) for monitoring on
                                your TV (from the TV VHF connector).

Please read the owner's manual carefully.  It has been prepared to assist
you during the initial set-up procedure and to guide you in everyday
operation of the Video Enhancer/Stabilizer.

CAUTION:  This unit can be permanently damaged by exposure to:

          Excessive heat (above 150 degrees F/65 degrees C)

          Moisture or humidity

          Excessive dust or dirt

          Take care to avoid these conditions at all times.

WARNING:  TO AVOID THE HAZARDS OF FIRE OR ELECTRICAL SHOCK, DO NOT EXPOSE
          THIS UNIT TO RAIN OR OTHER MOISTURE.

(br/all-7/21/94)

Privacy Policy