Color LCD TV
(160-3050)                 Operation                  Faxback Doc. # 58644

Using Your TV

1.  Extend the rod antenna and slide UHF/VHF/OFF to VHF or UHF.  The TV
    starts scanning and stops at the next active channel in the selected
    band.

2.  Press < TUNING > to tune to a different channel.  The tuning line on
    the screen aligns with the selected channel number below the screen.

3.  To adjust the volume, rotate VOLUME located on the right side of the
    TV.

4.  To adjust the picture to the desired brightness, rotate BRIGHT located
    on the right side of the TV.  The brightness also changes with the
    screen's angle.

Notes: If desired, fold out the stand on the back of the TV and lean the
       TV on a flat surface at a convenient angle.

       If reception is poor, adjust the length or angle of the rod antenna
       If the TV is inside a metal or concrete building, moving closer to
       a window might improve reception.

Backlight

In low temperatures, the TV screen takes a few seconds to light, or it 
might be slightly red in color.  This is not a malfunction.  Normal 
operation resumes after a few seconds.

Using an Earphone

For private listening, you can connect an optional earphone with a 1/8
inch plug to the EAR jack.  This automatically mutes the built-in speaker.

CAUTIONS:  Set VOLUME to the lowest setting before you begin listening.
           Then adjust the volume to a comfortable level.

           Do not use an earphone when operating a vehicle or riding a
           bicycle.  This can cause a traffic hazard and can be illegal
           in some areas.

(EB 2/17/00)