Color LCD TV with AM/FM Radio
(160-0184)                 Operation                  Faxback Doc. # 53335

Using the TV

1.  Set FM VHF AM UHF to either FM VHF or AM UHF to select the band.

2.  Extend the telescopic antenna.

3.  Slide TV OFF RADIO, located on the top of the TV, to TV.  The TV
    starts scanning and stops at the first active channel in the selected
    band.

4.  Press TUNING > or < to tune to a different channel.  The tuning line
    on the screen aligns with the selected channel number above the
    screen.

5.  To adjust the volume, rotate VOLUME located on the top of the TV.

6.  To adjust the picture to the desired brightness, rotate BRIGHT located
    on the top of the TV.  The brightness also changes with the screen's
    angle.

Notes:  If desired, fold out the stand on the back of the TV and lean the
        TV on a flat surface at a convenient angle.

        If reception is poor, adjust the length, angle, and direction of
        the telescopic antenna.  If you are using the TV inside a metal or
        concrete building, moving closer to a window might improve the
        reception.

Using the Radio

1.  Set TV OFF RADIO on top of the TV to RADIO.

2.  Slide the FM VHF UHF AM switch on the TV's right side to FM or AM.

3.  Rotate the FM AM TUNING dial on the right side of the TV to tune to
    the desired station.

4.  To adjust the volume, rotate VOLUME located on the top of the TV.

Note:  Adjust the length, angle and direction of the antenna for the best
       FM reception.  An internal antenna is used for reception of AM
       broadcasts.

Using an Earphone

For private listening, you can connect an optional earphone with a 1/8
inch plug to the EAR jack.  This automatically mutes the built-in speaker.

CAUTIONS:  Set VOLUME to the lowest setting before you begin listening.
           Then adjust the volume to a comfortable level.

           Do not listen at extremely high volume levels.  Extended high
           volume listening can lead to permanent hearing loss.

           Do not wear an earphone while operating a vehicle or riding a
           bicycle.  This can cause a traffic hazard and can be illegal in
           some areas.

           Even though some earphones allow you to hear outside sounds
           when listening at a normal volume level, they still can present
           traffic hazards.

Using the TV as a Monitor

You can play back the signal from an audio/video component connected to 
your TV using a Y-adapter cable (not supplied), available through your 
local RadioShack store (Cat. No. 42-2475).

Connect the cable's white plug to the component's video output jack and 
its red plug to the component's audio output jack.  then, plug the cable's 
sub-mini plug into the TV's AV IN jack.

(EB 7/1/99)

Privacy Policy