MOD-42 Cable Ready Stereo VCR
(160-0612)                 Controls/Accessories       Faxback Doc. # 41000

Accessories

Your Model 42 VCR comes with the Remote Control and several connection
accessories listed below.  Be sure you unpack all accessories before dis-
posing of the packing material.

  The 300-to-75 Ohm Adapter is used to connect 300-Ohm wire to the VHF
  input of the VCR.

  The 75-to-300/75 Ohm Cable is used to make VHF connections between the
  VCR output and your TV.

  The 300-Ohm Wire is used to make UHF connections between the VCR output
  and your TV.

Control Locations

The tuner programming controls are located in the small compartment on top
of the VCR cabinet.

The clock/timer controls and various other controls are located in the
compartment along the lower edge of the front panel.

WARNING:  TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK.  DO NOT EXPOSE THIS
          APPLIANCE TO WET LOCATIONS.

Copyright Information

Unauthorized recording or use of broadcast television programming, video
tape, film or other copyrighted material may violate applicable copyright
laws.  Radio Shack assumes no responsibility for the unauthorized duplica-
tion, use or other acts which infringe upon the rights of copyright owners.

CAUTION:  This unit can be permanently damaged by:

             Excessive heat (above 150 degrees F/65 degrees C)

             Moisture or humid conditions

             Exposure to excessive dust or dirt

Take care to avoid these conditions at all times.


CAUTION:  TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER.  NO
          USER-SERVICEABLE PARTS INSIDE.  REFER SERVICING TO QUALIFIED
          SERVICE PERSONNEL.


(LB/EB 8/5/97)