4.5 " B/W TV with AM/FM Radio
(160-0126B)                Operation                  Faxback Doc. # 38570


TV OPERATION

1.  Turn VOLUME clockwise to turn on the TV/radio.

2.  Set FUNCTION AM/FM to TV.

3.  Set VHF-LOW/VHF-HIGH/UHF to the desired band.

    Channels                 Switch

    2 through 6              VHF-LOW
 
    7 through 13             VHF-HIGH

    above 13                 UHF

4.  Turn TUNING to the desired station.

5.  Adjust the built-in telescoping antenna for the best picture and sound.

6.  Turn BRIGHT and CONTRAST on the back of the TV/radio until the desired
    picture appears.

7.  Turn V-HOLD on the back of the TV/radio to stop a TV picture's vertical
    roll.

8.  Turn VOLUME to the desired sound level.

9.  Turn VOLUME counterclockwise until it clicks to turn off the TV/radio.

TV Reception Tips

If the image is blurry, unstable or has "snow," the signal reception might
be weak.  This can be caused by your location or the telescoping antenna's
position and length.  Buildings with steel construction can also cause
reception problems.  Try changing the antenna's position and length.  If
this does not help, use an outdoor antenna.

If the image does not fill the screen during battery power operation, the
batteries are weak.  Check and replace or recharge the batteries as needed.

RADIO OPERATION

1.  Turn VOLUME clockwise until it clicks to turn on the TV/radio.

2.  Set FUNCTION AM/FM/TV to AM or FM as desired.

3.  Slowly turn TUNING to the desired station.

4.  Turn VOLUME to the desired sound level.

5.  Turn VOLUME counterclockwise until it clicks to turn off the TV/radio.

Radio Reception Tips

Weak FM reception is generally caused by the problems described in "TV
Reception Tips."  Use an outdoor antenna for very weak stations.

Weak AM reception might be caused by the distance from the station or by 
operating the TV/radio in a building with steel construction.  Turn the
TV/radio in different directions for the best reception.

(km-03/25/1997)

Privacy Policy