Model 20 19" Color TV/VCR
(160-0412)                 TV Operation               Faxback Doc. # 38160

Basic TV Operation

Before you operate the TV/VCR, be sure you have made all the necessary
connections described in "Getting Started".

Using the TV/VCR's Front Panel Controls

NOTE:  The controls are located under the flip-down door on the bottom,
       front of the TV in the center.  Press door to open and gain access
       to controls.

POWER - Press POWER to turn the TV/VCR on or off.  The power button lights.

NOTE:  Power turns on automatically when a cassette tape is loaded.  If you
       load a tape without the erase protection tab, the video program
       automatically plays.

TV/VCR - Press TV/VCR to select the TV or CABLE TV mode.  Select TV to view
         regular broadcast; select CATV to view cable channels.

NOTE:  When you select TV, CH and the current channel number appear on the
       screen.  When you select CATV, CATV and the current channel number
       appear on the screen.

CH (channel) /\ - \/ - Press CH /\ to select the next higher channel in the
       current band and press CH \/ to select the next lower channel in the
       current band.  Press and hold down either button to quickly scroll
       through channels.  See "Using Automatic and Manual Channel Program-
       ming."

Using the Remote Control

The remote control has the same controls as the TV/VCR's front panel.  The
remote control also has additional controls.

To operate the TV/VCR's control, point its front window towards the TV/VCR's
remote control sensor.  Then press the desired button(s) on the remote
control.

This section describes the controls found only on the remote control.

DISPLAY - Press DISPLAY to view the channel number, the operation mode, the
          tape counter, speed and the current time.  After 5 seconds, it
          disappears.  Press again within 5 seconds and the channel number
          and the tape counter appears on the screen.  To clear the channel
          number and the tape counter, press again.

SET-UP - Use SET UP to select the channel memory and ON/OFF timer. See "Set
         Up Functions."

MENU - Use MENU to select the clock set, programmable recording (normal,
       daily, weekly), and program review.


(EB 2/26/97)

Privacy Policy