KV27S15 Sony Television
(160-2084) Operating Video Equipment Faxback Doc. # 37670
Operating video equipment
You can operate Sony or non-Sony video equipment that has an infrared
remote sensor with the supplied remote commander. For this operation, set
the manufacturer's code number.
Setting the manufacturer's code
While pressing CODE SET, press 0-9 to enter the manufacturer's code number
(see the chart in the right column). For example, to operate a Sony 8 mm
VCR, press 0, 2 and ENTER.
VCR Manufacturer Code numbers
Manufacturer Code number
SONY 01, 02, 03
CANON 05
EMERSON 22, 30, 33
FISHER 10, 11, 12, 15
FUNAI 29
GENERAL ELECTRIC 05, 08
GOLDSTAR 25
HITACHI 07, 08, 36
JVC 16, 35
MAGNAVOX 05, 06, 09
MITSUBISHI 18, 19, 26, 27
MULTITECH 29
NEC 16, 23, 31
PANASONIC 05, 06, 37
PHILCO 05, 06
PHILIPS 05, 06, 09
QUASAR 05, 06
RCA 07, 08
SAMSUNG 24, 32
SANYO 11, 15
SCOTT 21
SHARP 13, 14
SHINTOM 34
SYLVANIA 05, 06, 09
SYMPHONIC 29
TEKNIKA 28, 29
TOSHIBA 20, 21
TOTE VISION 25
ZENITH 17
MDP manufacturer code numbers
Manufacturer Code number
SONY 04
KENWOOD 58
MAGNAVOX 52
MARANZ 54
MITSUBISHI 51
PANASONIC 55
PHILIPS 52
PIONEER 51
RCA 51
SANYO 57
SHARP 56
YAMAHA 53
Notes:
If more than one code number is listed, try entering them one by one,
until you come to the correct code for your equipment.
In some rare cases, you may not be able to operate your non-Sony video
equipment with this remote commander. This is because your equipment
may use a code that is not provided with this remote commander. In
this case, please use the equipment's own remote control unit.
The code numbers for Sony equipment are assigned at the factory as
follows:
Beta, ED Beta VCRs 01
8 mm VCR 02
VHS VCR 03 (preset code for this remote
commander)
Caution
When you remove a battery from the remote commander, the code may
revert to 03. Reset the code each time you replace the battery, if
necessary.
Use the video operating buttons on the remote commander to operate the
video equipment.
Operating a VCR Buttons on the remote commander
To turn on or off Press POWER
To change channels Press CH +/-
To record Press and REC simultaneously
To play Press ->
To stop Press STOP
To fast forward Press ->>
To rewind the tape Press <<-
To pause Press ||
To search the picture Press ->> or <<- during playback
forward and backward
Operating the laser-disc Buttons on the remote commander
player
To play Press ->
To stop Press STOP
To pause Press ||
To resume normal playback, press again.
To search the picture Keep pressing ->> or <<- during playback
forward and backward
To resume normal playback, release the
button.
To search the chapter Press CH +/-
Note:
If the video equipment does not have a certain function, the
corresponding button this remote commander will not operate.
(br/km-01/31/1997)
Privacy Policy