CC-436 RCA CamCorder
(160-0831)                 Color Enhancement Light    Faxback Doc. # 37070

The color enhancement light helps create brighter, sharper pictures.

To Use the Color Enhancement Light

1.  Attach the rechargeable battery or AC adapter/charger to power the
    camcorder.

2.  Press and hold the small button on CAMERA/OFF/VCR and place it in
    CAMERA.

3.  Select a position for the LIGHT AUTO/OFF/ON switch.

      Place in AUTO to have the light automatically turn on when the cam-
      corder is aimed at a dark object and turn off when aimed at a bright
      object.

      NOTE:  A cassette must be inserted for AUTO to operate.

      Place in ON to have the light turn on whenever CAMERA/OFF/VCR is in
      CAMERA.

      Place in OFF to turn off the light.

If the camcorder is left in record pause for more than five minutes, the
power and light automatically turn off.  Press REC/PAUSE to turn camcorder
back on.

NOTES:  Turn on the light only when you need it.  The power consumption of
        the light is approximately two-thirds that of the camcorder.  When
        the light is on, the operation time of the rechargeable battery is
        reduced.

Avoid bumping or shaking the light when in use.  The light's bulb is sensi-
tive when hot and may burn out.

Do not allow water to drop on the light when in operation.

DANGERS:  During operation and after using the light, the front surface and
          bulb of the light will be very hot.  To avoid burns, do not touch
          them.

          To prevent overheating, do not block or cover the ventilation
          holes on the color enhancement light.

          Never use the color enhancement light in the vicinity of explo-
          sives or highly flammable materials.

Removing and Replacing the Front Case of the Light

To Remove and Replace Light Case

1.  To remove front case, press and hold the lower hook while removing it.

2.  Replace the front case, pass the bulb through the hole of the reflec-
    tion plate, and attach the lower hook to the light.

3.  Press front of case to light.

NOTES:  Do not touch the bulb with your fingers. It may shorten its service
        life.

        Make sure the front case of the light is properly attached after
        removing it or replacing a bulb.

        When replacing the bulb, only use #221111 to reduce the risk of fire
        and other hazards.

        See the installation instructions packed with the replacement bulb
        when replacing the bulb.

CAUTION:  Use only bulb # 221111 when replacing the bulb to reduce the risk
          of fire or other hazards.


(BR/EB 10/24/96)

Privacy Policy