Model 801
(160-0655)                 Selection TV/Cable         Faxback Doc. # 31369

If you connected your VCR to cable TV, follow the directions to select
CATV.  If you connected your VCR to the antenna, follow the directions to
select TV.

1.  Press PROG to display the MENU screen.

2.  Press 3 to select the MODE SET menu.

3.  Press 2 to change from TV to CATV or CATV to TV.  If you select
    CATV/CATV appears on the VCR's display.

4.  Press PROG twice to return to the normal screen.

PROGRAMMING CHANNELS INTO MEMORY

You can program the tuner's memory so when you press CHANNEL \/ or /\, the
VCR's tuner scans only the active channels in your area.  Use the remote
control to program the tuner's memory.

1.  Turn on the VCR and the TV.

2.  Select the tuner band you want to program.

3.  Press A.PROG.

    The VCR scans all the channels in your area and stores active channel
    numbers into memory.  Then the VCR stops on the lowest memorized
    channel.

4.  Press CHANNEL \/ or /\ to check the memory's contents.  The memorized
    channel numbers appear on the VCR's display window.

ADDING OR DELETING A CHANNEL

If the tuner stores a channel that you do not want, tune to that channel
and press ERASE.  The channel is now removed from memory.

If you want to program a weak channel that automatic programming missed,
enter that channel number using the remote control's number buttons.  Then
press ADD.  The channel is now added to memory.

BASIC OPERATION

SELECTING THE TV/VCR INPUTS AND OUTPUTS

When VCR appears on the display, the VCR signal is sent to the TV though
the OUT TO TV terminal.

When VCR is not on the display, antenna or cable signals (connected to the
IN FROM ANT terminal) pass through to the TV through the OUT TO TV terminal
unaffected.  You can use the TV tuner to select channels as if the VCR was
not there.

If the VCR is turned on, the VCR signal is sent to the AUDIO/VIDEO OUT
jacks, regardless of the TV/VCR setting.

Audio Output Selection

To hear stereo sound from the VCR, you must connect a cable from the VCR's
AUDIO OUT L and R jacks to a stereo TV or stereo amplifier/receiver.

Press OUTPUT to select the audio source you want the VCR to play back.
Each time you press OUTPUT, the sound you hear changes from stereo to left
audio channel only to right audio channel only and then back to stereo.

The on-screen status display shows the audio output selected when you press
OUTPUT.  If the audio was recorded with AUDIO LINE-IN set to STEREO, STEREO
(both channels), L (left channel) or R (right channel appears on the
screen.  If the audio was recorded with AUDIO LINE-IN set to DUAL, the
display changes from MAIN (left channel only) to SUB (right channel only)
to MIX (both channels).

NOTES:  The OUTPUT button is especially useful when you record the main
        signal on the left channel and a different SAP signal on the right
        channel.

        If you play a tape that was not recorded in stereo, your VCR
        plays it in monaural audio, regardless of the OUTPUT setting.

        The audio output setting has no effect on recording.  The VCR
        records whatever type of audio signal it receives.


(SP/br 3/19/96)

Privacy Policy