Model-84 VHS HQ VCR
(160-0522)                 Preparation                Faxback Doc. # 31337

SETTING THE CLOCK

Set the clock accurately for proper automatic timer recording.  We suggest
that you use a TV or radio station as your time source.

NOTE:  For "Setting the Clock" and "Automatic Timer Recording", the
       instructions refer to the TV's on-screen display indicators.  Some
       of the indications on the VCR's display vary slightly.

In the following example, the clock is set to 5:40 p.m. Wednesday.

1.  Plug the VCR power cord into a standard AC outlet.  The display
    flashes --:--.

2.  Press [POWER] to turn on the VCR.

3.  Turn on your TV and set it to the same channel as the VCR's 3CH/4CH
    switch (located on the back of the VCR).  Then, press [TV/VCR] on the
    remote control unit so that VCR appears on the display.

    NOTE: If you use a TV monitor, be sure to set it to the video mode.

4.  Press [CLOCK SET].  The day indicator flashes.

5.  Press [SET] until the desired day indicator is displayed (WED, for
    example).

6.  Press [SELECT].  The hour digits flash.

    Then, press [SET] until the desired hour is displayed (PM 5:00, for
    example).

    The Model 84 uses an a.m./p.m. clock.  Be sure that AM or PM is
    correctly displayed.

7.  Press [SELECT].  The minute digits flash.

    Then, press [SET] until the desired minute is displayed (PM 5:40, for
    example).

8.  Press [CLOCK SET] to start the clock.

    Although seconds are not displayed, they begin counting at 00 when you
    press [CLOCK SET].  Use this feature to set the clock as accurately as
    possible.

If the display shows an abnormal reading or no reading, unplug the power
cord for about 5 seconds.  Then, plug it back in.


(RF/all-03/22/96)

Privacy Policy