Sony CCD-TR83 Handycam
(160-8408) Advanced Operations Faxback Doc. # 31267
USING ALTERNATIVE POWER SOURCES
You can choose any of the following power sources for your camcorder:
battery pack, house current, and 12/24 V car battery. Choose the
appropriate power source depending on where you want to use your camcorder.
PLACE POWER SOURCE ACCESSORY TO BE USED
INDOORS House current AC power adapter AC-V25A/V25B/V25C/
V15 (supplied), AC-S10
OUTDOORS Battery Pack Battery pack NP-55 (supplied),
NP-80/80D, NP-77H, NP-68, NP-66H,
NP-C65, NP-60D
IN THE CAR 12 V or 24 V
car battery DC pack DCP-77
NOTE ON POWER SOURCES
Disconnecting the power source or removing the battery pack during
recording and playback may damage the inserted tape. If this
happens, restore the power supply again immediately.
USING HOUSE CURRENT
FOR THE CUSTOMERS SUPPLIED WITH THE AC-V25A/V25B/V25C AC POWER ADAPTER
1. Lift up the viewfinder.
2. Connect the AC power cord to a wall outlet. Connect the bottom of the
AC power adaptor to the battery mounting surface of the camcorder.
3. Set the selector to VTR (DC OUT).
WARNING: The power cord must only be changed at a qualified service shop.
PRECAUTION: The set is not disconnected from the AC power source (mains)
as long as it is connected to the wall outlet, even if the set
itself has been turned off.
NOTES: The POWER lamp will remain lit for a while even if the unit is
unplugged after use. This is normal.
If the POWER lamp does not light, set the selector to the center
positions (AC-V25A/V25B/V25C only) and disconnect the power cord.
After about one minute, reconnect the power cord and set the
selector to VTR (DC OUT) again.
TO REMOVE THE ADAPTER
The adapter is removed in the same way as the battery pack.
(YO/SP 3/13/96)
Privacy Policy