Model 151 MovieCorder
(160-0852)                 Copying a Tape             Faxback Doc. # 18465

The process of copying from the camcorder to the VCR is called dubbing.
You can use VHF signals to make such copying, but separate audio/video
signals are preferred.

1.  Connect the audio/video output cable's multi-pin plug to the 
    camcorder's AV OUT jack.

2.  Connect the audio/video output cable's video plug (yellow) to the
    VCR's video input.

3.  Connect the audio/video output cable's audio plug (white) to the VCR's
    audio input.

    If your VCR is stereo, use a Y-adapter to connect the white plug to
    both audio inputs.

4.  If your VCR has an input select switch, set it to record audio/video
    inputs.  This is automatic on some VCRs.

5.  Set the camcorder's EDIT switch to ON.

6.  Begin recording on the recording VCR and playback from the camcorder.

You can watch the tape on the TV connected to your VCR while you copy the
tape.  See your VCR's owner's manual.

When you finish copying a tape, set the EDIT switch to OFF.


(CS 11/6/95)

Privacy Policy