MODEL 100 4-Head (160-0618) Troubleshooting Faxback Doc. # 15696
VHS Stereo Hi-Fi VCR
If the follow the instructions in this manual and still have trouble
operating you VCR refer to the following troubleshooting chart.
SYMPTOM POSSIBLE CAUSE CORRECTIVE ACTION
No Power. The power cord is not Plug in the power
connected. cord to an AC
outlet.
Timer recording is The problem timer is not Set the program
not possible. set or set incorrectly. timer correctly.
The power is on. Turn off the
power.
Record mode cannot be The erase-protection tab Place a piece of
engaged. is missing. plastic tape over
the tab hole.
Picture is poor The TV channel selector On playback, set
on playback. is not set to the proper TV channel
channel. selector to
Channel 3 or 4.
The TV fine is not set Fine tune your
correctly. TV.
Audio/video connections Double check all
are incorrect. connections.
Video distortion on The video head is Have the video
playback. dirty. head cleaned.
The tracking is not Adjust the
properly adjusted. tracking for a
better picture.
No picture on The TV is not set to the Set it to the
playback. proper channel. correct channel
(Channel 3 or 4).
Audio/video connections Double check all
are incorrect. connections.
Operation buttons do The dew sensor is activated. Wait until the
not work when the sensor is de-
power is on and activated, and
the cassette is then proceed with
is inserted. operation.
The safety device in Try to press EJECT
your VCR is functioning. several times.
Unplug the VCR and
plug it in again
after one full
minute.
Off-the-air TV The connections are not Recheck the
programs cannot correctly made. connections.
be seen.
Not operation by remote The batteries are weak Replace the
control. or dead. batteries.
(LB/all-06/19/95)
Privacy Policy