| Question: How do I set the announcement? |
Answer: Follow the steps below to set the announcement.
- Press and release CHANGE. The Message Window displays CH.
- Press and release ANNC. The system beeps. Speak toward the microphone normally, from about 9 inches away. While you are recording, the Message Window displays the elapsed time of your recording.
- Press STOP when you are finished. The system automatically plays back your announcement.
Back to Telephone Answerer Index
|
|
Question: Why is CL flashing, and how do I set the time? |
Answer: CL flashing on the display indicates that you need to set the clock. Setting the Time
- Press and release CHANGE. The Message Window displays CH.
- Press and release CLOCK. The current day setting is announced.
- To change the day setting, hold down SKIP/SCAN or REPEAT/SCAN until the correct day is announced. Then release the button.
- Press and release CLOCK. The current hour setting is announced.
- To change the hour setting, hold down SKIP/SCAN or REPEAT/SCAN until the correct hour is announced. Then release the button.
- Press and release CLOCK. The current minutes setting is announced.
- To change the minutes setting, hold down SKIP/SCAN or REPEAT/SCAN until the correct minutes setting is announced. Then release the button.
- Press and release CLOCK. The new day and time are announced. To check the clock, press and release CLOCK.
Back to Telephone Answerer Index
|
| Question: Is there additional information available on-line? |
Answer: Additional information is available on our on-line support page for this product.
Back to Telephone Answerer Index
|
About RadioShack Corporation | Contact Us | Privacy Policy | Store Locator
Copyright© RadioShack Corporation 2004. All rights reserved.
|
