| Question: How do I adjust the ringer on the base? |
Answer: You can make the base's ringer sound high or low. Set RING VOL on the back of the base to either HI or LOW as desired. To turn off the base's ringer, set RINGER VOL to OFF. When a call comes in, the handset (if it is off the base) and any telephone connected to the same line as the TAD-1017 still ring, but the base does not.
Back to Telephone Answerer Index
Back to Cordless Index
|
| Question: How do I record an OGM (OutGoing Message)? |
Answer: Follow the steps below to record an outgoing message.
- Press FLASH/REMOTE on the handset so the TALK/BATT LOW indicator lights green.
- Hold down OGM REC/8 for about 2 seconds until the handset beeps. Then speak your outgoing message into the handset.
- The TAD automatically stops recording after 1 minute, or you can press STOP/7 when you finish the message. The handset beeps, plays back the message, then beeps again.
Note: If your message is less than 2 seconds long, the TAD does not recognize it as a new message and plays back the previous pre-recorded message. Re-record your message and make sure it is longer than 2 seconds.
- Press FLASH/REMOTE so the TALK/BATT LOW indicator turns off.
Back to Telephone Answerer Index
Back to Cordless Index
|
| Question: Is there additional information available on-line? |
Answer: Additional information is available on our on-line support page for this product.
Back to Telephone Answerer Index
Back to Cordless Index
|
About RadioShack Corporation | Contact Us | Privacy Policy | Store Locator
Copyright© RadioShack Corporation 2004. All rights reserved.
|
