| Question: What are the wiring instructions? |
Answer: The alarm is wired as follows:
- Red wire goes to positive.
- Black wire goes to ground.
- Yellow wire goes to the antenna.
Back to Index
|
| Question: Why does it beep three times? |
Answer: If the system detected a violation while you were away, it chirps three times when you disarm it.
Back to Index
|
| Question: How do you adjust the sensitivity? |
Answer: Follow the steps below:
- With the alarm disarmed, hold down FINDER until the alarm sounds four tones.
- Within 2 seconds, strike your vehicle with as much force as you want the alarm to respond to. The alarm sounds three tones. Any shock equal to or greater than the setting triggers the alert.
Notes:
- If you do not strike your vehicle within 2 seconds, the alarm is set to its highest sensitivity. This could cause frequent false alerts.
- The shock sensor does not operate for 8 seconds after the system is armed.
Back to Index
|
| Question: Who can I contact for additional information? |
Answer: You will need to contact Bulldog Security. Please note, this internet site is not affiliated with RadioShack Corporation and off-site information is neither created, maintained nor verified by RadioShack Corporation. Responsibility for the content rests solely with the page owner(s).
Back to Index
|
About RadioShack Corporation | Contact Us | Privacy Policy | Store Locator
Copyright© RadioShack Corporation 2004. All rights reserved.
|
