PRO-96 (200-0526) Tutorial: How to Search a Preprogrammed Frequency Range
This tutorial will show you how to use the scanner's
search banks. There are six search banks SR0 - SR-5 that contain
preprogrammed search ranges. A seventh search bank SR6 is user
configurable and a specific range of frequencies can be searched
programming the lower and higher end frequency.
For additional information on this product, see the links below:
Press SRCH until you find the search bank SR0 - SR5 that you want to listen to.
Step 2: Search Marine and CB Banks
In the Marine search bank SR0 and the CB search bank SR1 the frequency can be selected directly by entering the channel numbers or by using the up and down arrow keys.
Step 3: Select/Deselect Group Bank in SR3 and SR5
The Police/Fire search bank SR3 and the Ham search bank SR5 contain groups that can be turned on or off. To turn off a group, press the corresponding number key and press it again to turn the group back on. In this case group 0 in Police/Fire search bank SR3 was turned off.
Step 4: Search the Band
To scan the search banks press FUNC then SRCH. M will change to S. Press FUNC the SRCH to return to manual mode.
Program the User Configurable Search
Bank SR6
Step 1: Enter the Program Mode
Press PGM then SRCH. PSR will display in the top left corner and the cursor will flash on the letter L.
Step 2: Enter and Set the Lower Frequency
Use the number and ./DELAY keys to enter the lower frequency. Press ENTER. The cursor will flash on the H.
Step 3: Enter and Set the Higher Frequency
Use the number and ./Delay keys to enter the higher frequency. Press ENTER.
Step 4: Adjust the Squelch and Start the Search
To start the search rotate the Squelch knob clockwise until the hissing noise stops. Press SRCH. When the scanner finds an active frequency the search will stop.
