PRO-2018 (200-0424) Tutorial: How to Store Known Frequencies Into Channels

This tutorial will show you how to store frequencies into the channels of your scanner. The PRO-2018 has 10 channel banks and each bank stores 20 channels.

For additional information on this product, see the links below:

Step 1: Select the Channel



Press the PGM key and enter the number of the channel into which you want to store the frequency. In this case channel 6 was used.

Step 2: Enter the Program Mode



Press the PGM key, and the channel number will appear.

Step 3: Enter the Frequency



Using the numbered keys on the keypad and the decimal point key " ", enter the desired frequency that you want to store.

Step 4: Store the Frequency



Press the ENT key which will store the chosen frequency into the channel. Numbers are automatically rounded down to nearest valid frequency, e.g. 151.473 would display as 151.4700. Note: If you make a mistake in this step, the word "*Error" appears on the display and the scanner will beep 3 times when you press the ENT* key. All you have to do is start over from "Step 3: Enter the Frequency".

Step 5: Program Frequencies into the Next Channel



In order to program a frequency into the next channel, press the PGM key and repeat Steps 3 through 4.