| Problem: The power does not come on. |
Possible Cause |
Suggested Solution |
| The power cord is disconnected or there is no power to the outlet. |
Check the cord and outlet. |
| The protection circuit is activated. |
Unplug the power cord and plug it back in. |
| There may be loose strands of wire touching the back of the receiver and triggering the protection circuit. |
Remove any excess wire from behind the receiver. |
|
Back to the Troubleshooting Index
|
| Problem: The unit does not respond when any button is pressed. |
Possible Cause |
Suggested Solution |
| There may be a system lockup caused by static discharge. |
Unplug the power cord and plug it back in. |
|
Back to the Troubleshooting Index
|
| Problem: The display shows a message that is not documented in the manual, and it won't go away. |
Possible Cause |
Suggested Solution |
| There may be a system lockup caused by static discharge. |
Unplug the power cord and plug it back in. |
|
Back to the Troubleshooting Index
|
| Problem: M-ERROR is on the display. |
Possible Cause |
Suggested Solution |
| There is a memory error; the unit needs to be reset. |
Unplug the power cord and plug it back in. |
|
Back to the Troubleshooting Index
|
| Problem: CD ERROR or DISC ERROR is on the display. |
Possible Cause |
Suggested Solution |
| The CD is loaded incorrectly. |
Remove the CD and reload it. |
| The CD is dirty. |
Remove the CD and clean it. |
| The CD is damaged. |
Replace the CD. |
|
Back to the Troubleshooting Index
|
| Problem: ERROR 7 is on the display. |
Possible Cause |
Suggested Solution |
| The CD is loaded incorrectly. |
Remove the CD and reload it. |
| The CD is dirty. |
Remove the CD and clean it. |
| The CD is damaged. |
Replace the CD. |
| There is a memory error; the unit needs to be reset. |
Unplug the power cord and plug it back in. |
| |
|
|
Back to the Troubleshooting Index
|
| Problem: The sound from the CD player skips. |
Possible Cause |
Suggested Solution |
| The CD is dirty. |
Remove the CD and clean it. |
| The CD is damaged. |
Replace the CD. |
|
Back to the Troubleshooting Index
|
| Problem: The sound from the tape player is noisy or distorted. |
Possible Cause |
Suggested Solution |
| The tape is dirty. |
Remove the tape and clean it. |
| The tape heads needs cleaning. |
Clean and demagnetize the tape heads. |
| The tape is damaged. |
Replace the tape. |
|
Back to the Troubleshooting Index
|
| Problem: READ is on the CD player display, but the CD isn't playing. |
Possible Cause |
Suggested Solution |
| The reading mechanism or laser-eye needs cleaning. |
Use a CD player cleaner. |
| The reading mechanism or laser-eye is out of alignment. |
Take the player to your local RadioShack store and have it sent to service. |
|
Back to the Troubleshooting Index
|
About RadioShack Corporation | Contact Us | Privacy Policy | Store Locator
Copyright© RadioShack Corporation 2004. All rights reserved.
|
