256K Desktop Electronic Organizer w/Call ID/Call Wait ID
(650-0790)                 Preparation                Faxback Doc. # 60144

Installing Batteries

You need four AAA batteries (not supplied) to protect the organizer's 
memory during a power failure.  For the longest operation and best 
performance, we recommend you use RadioShack alkaline batteries.

CAUTIONS:  Always use fresh batteries of the required size and recommended 
           type.

           Do not mix old and new batteries, different types of batteries 
           (standard, alkaline, or rechargeable) or rechargeable batteries
           of different capacities.

           Always remove old or weak batteries.  Batteries can leak 
           chemicals that can damage your system.

           If you are replacing the batteries, make sure the supplied AC
           adapter is securely connected to an AC outlet and to your 
           organizer.   Otherwise, you might lose stored information.

WARNING:  Dispose of dead batteries promptly and properly.  Do not bury or 
          burn them.

Follow these steps to install the batteries.

1.  If you are replacing the batteries, unplug both modular telephone line
    cords from the back of the system.
 
2.  Use a Phillips screwdriver to remove the screw in the battery
    compartment cover.
 
3.  Use a curved object such as a paper clip to pry off the battery
    compartment cover.
 
4.  Insert the batteries in the compartment as indicated by the polarity
    symbols (+ and -) marked inside.
 
5.  Close the cover and secure it with the screw.  If you are replacing 
    the batteries, reconnect the phone line and the phone.

When (crossed battery symbol) appears, replace the batteries.

Connecting The AC Adapter

You must connect the supplied AC adapter to the organizer to power it.  
Plug the AC adapter's barrel plug into the 9V DC jack on the back of the 
organizer, then plug the AC adapter into a standard AC outlet.

CAUTION:  You must use a Class 2 power source that supplies 9 volts DC and 
          delivers at least 500 mA. Its center tip must be set to positive
          and its plug must fit the organizer's 9V DC jack.  The supplied
          adapter meets these specifications.  Using an adapter that does
          not meet these specifications could damage the organizer or the
          adapter.

Initializing The Organizer

Initialize your organizer before you use it the first time after 
connecting it to AC power, or when you want to delete all stored records, 
alarms, and the password.

Important:  This procedure deletes all stored information!

1.  Use a pointed object such as a straightened paper clip to press RESET
    on the bottom of your organizer.  CLEAR ALL DATA? (Y/N) appears.
 
2.  To delete all stored records, alarms and the password, press Y.  Or,
    press N to cancel.

Connecting The Organizer To The Phone Line

The organizer connects to any modular phone line jack and your phone.  If 
your telephone or line does not have modular jacks, you can purchase the 
necessary adapters at your local RadioShack store.  Or, you can have your 
local telephone company update your wiring.

Notes:  The USOC number of the jack to be installed is RJ11C (or RJ11W for 
        a wall plate jack).

        Your organizer dials using standard touch tones.  If you do not 
        subscribe to touch-tone service, you must order this service from 
        your local telephone company.

Follow these steps to connect the organizer to the phone line.

1.  Disconnect the modular phone line cord (running from the wall jack) 
    from your telephone and plug it into the organizer's TO LINE jack.

2.  Plug one end of the supplied modular telephone cord into the
    organizer's TO PHONE jack.

3.  Plug the other end of the cord into the phone's jack.

(LB EB 6/9/00)

Privacy Policy