EC-366 Electronic Organizer
(650-0872)                 Care and Maintenance       Faxback Doc. # 41146


To enjoy your RadioShack EC-366 3K Pager ID Electronic Organizer by
Rolodex for a long time:

   Keep the EC-366 dry.  If it gets wet, wipe it dry immediately.

   Handle the EC-366 gently and carefully.  Don't drop it.

   Use and store the EC-366 gently only in normal temperature environments.

Note:  At very low temperatures, the display's response time might slow
       down or it might fail completely.  This is only temporary.  Your
       EC-366 returns to normal operation at warmer temperatures.

   Keep the EC-366 away from dust and dirt.

   Wipe the EC-366 with a damp cloth occasionally to keep it looking new.

Modifying or tampering with your EC-366's internal components can cause a
malfunction and might invalidate the organizer's warranty.  If your EC-366
is not performing as it should, take it to your local RadioShack store for
assistance.

RESETTING THE EC-366

If the EC-366 stops working properly or you forget your password, follow
these steps to reset it.

1.  Press TIME/DATE so the day, time, and date appear, then press and hold
    SPACE until DELETE? Y/N appears on the display (about 6 seconds).

2.  Press Y (yes) to delete all information stored in memory, or press N
    (no) to reset only the day, time, date, and password (and keep all
    stored information).  The day, time, and date reappear on the display.

Note:  If your EC-366 still does not work properly or if the display locks
       up, try initializing it and/or replacing the main battery.

REPLACING THE BATTERIES

Your EC-366 is powered by one 3-volt CR2025 lithium battery (RadioShack 
Cat. No. 23-161), and is backed up by one 3-volt CR2016 lithium battery
(Cat. No. 23-160).  When the EC-366's display dims or stops working
properly, replace the main battery.

Note:  Replace the backup battery after about 3 years of operation.

Warnings:

Keep batteries out of reach of children.  Swallowing a lithium battery can
be fatal.

Always dispose of an old battery promptly and properly.

Cautions:

Always use a fresh battery of the required size and type.

To avoid losing the information stored in your EC-366, do not remove both
batteries at the same time, and do not press any buttons while you replace
a battery.

Replacing the Main Battery

Follow these steps to replace the EC-366's main battery.

1.  Use a small Phillips screwdriver to remove the screws from the
    battery compartment cover, then lift up the cover to remove it.

2.  Remove the old battery and insert the new battery with the positive (+)
    side facing up.

3.  Replace the cover, then reinsert and tighten the screws.

Replacing the Backup Battery

1.  Use a small Phillips screwdriver to remove the screws from the battery
    compartment cover, then lift up the cover to remove it.

2.  Remove the caution sticker from the backup battery, then set the
    sticker aside.

3.  Use a small Phillips screwdriver to remove the screw from the tension
    bar holding the backup battery in place.

4.  Press on the main battery to hold it in place and carefully lift up
    and slide the tension bar toward the main battery.

5.  Use a small Phillips screwdriver to gently lift the backup battery,
    then pull it out to remove it.

6.  Insert the new battery with the positive (+) side facing up.

7.  Press on the main battery to hold it in place, and carefully lift up
    and slide the tension bar back in place over the backup battery.  Then
    reinsert and tighten the screw in the tension bar.

8.  Place the caution sticker over the backup battery.

9.  Replace the battery compartment cover, then reinsert and tighten the
    screws.

(km-08/18/1997)