EC-366 Electronic Organizer
(650-0872)                 Preparation                Faxback Doc. # 41144


REMOVING THE BATTERY INSULATION SLIPS

Your EC-366 comes with two battery insulation slips, designed to preserve
battery power.  Before you use the EC-366, you must remove the battery
insulation slips.

Each battery slip has a tab that extends outside the battery compartment
cover.  To remove the slips, grasp each tab and firmly pull on it to slide
the slip out of the battery compartment.

Note:  If you are unable, to easily slide a slip out of the compartment,
       or if you are not sure the entire slip was removed, you can open
       the battery compartment cover to remove the slips.

OPENING/CLOSING THE COVER

The EC-366's keys are protected by a cover to avoid damage or unwanted
input.  To open the cover, press down on the recessed tab and lift the cover
so it stands upright.

To close the cover, simply press it down until it locks into place.

INITIALIZING THE EC-366

You should initialize your EC-366:

    Before you use it for the first time.

    If your EC-366 is exposed to a strong static electrical charge, and the
    display locks up.

Caution:  Initializing the EC-366 deletes all stored information!

Follow these steps to initialize the EC-366.

1.  Press and hold down the period (.) key and the 8 key at the same time.

2.  While pressing these keys, insert a pointed object (such as a
    straightened paper clip) into the RESET hole on the bottom of the 
    EC-366, then press it gently.  The display shows a variety of test
    characters, then 3K OK appears.

Note:  If NON-3K OK appears on the display, there might be a problem with
       the EC-366's memory.  Take it to your local RadioShack store for
       assistance.

3.  Release the period and 8 keys.

4.  Press RESET again.  The default day, time, and date appear on the
    display, and the EC-366 is ready for use.

Note:  If your EC-366 still does not work properly, replace the batteries.

(km-08/15/1997)