EC-439 Data Organizer
(650-0849)                 Password                   Faxback Doc. # 17149

Password security allows you to keep confidential data in protected
Telephone Directory, Memo and Expense Manager directories.  The password
can be up to 8 characters in length.

Be sure to write your secret password in a safe place.  If you cannot
remember the password there is no way of retrieving it from the unit
without resetting the entire unit and losing all other data information in
the unit.

Setting the Password (if no password in memory).

1.  Press <CTRL> <PASSWORD>.  Display prompts password to be entered.

2.  Type your password up to 8 characters in length.  Write down in a safe
    place as a back-up, and press <ENTER> to confirm.

3.  The security key indicator will appear on the display to show unit is
    now in secret mode.

4.  After inputting secret data, press <CTRL> <PASSWORD> to exit secret
    data mode.

NOTE:  Secret data registers can only be accessed in secret data mode.
       While in secret mode, entering non-secret modes turns off the
       security key indicator on the display.  Entering a mode with secret
       register will illuminate security key indicator on display to
       indicate unit still in secret mode.

Entering Secret Data Mode

1.  Press <CTRL> <PASSWORD> and input password.

2.  "CORRECT PASSWORD" appears on the display to confirm secret data mode
    has been opened.

3.  Perform data operations in secret data mode.

4.  Press <CTRL> <PASSWORD> to leave secret data mode.

NOTE:  If incorrect password is input, "INCORRECT PASSWORD" will appear on
       the display.  After three incorrect attempts, unit will not allow
       secret password to be entered for approximately 10 minutes.

Changing Secret Password

1.  In non-secret mode, press <CTRL> <PASSWORD> and type in correct
    password.  "CORRECT PASSWORD" will appear on the display.

2.  Press <CTRL> <PASSWORD> again and input new password.

3.  Press <ENTER> to confirm or any mode key to keep old password.

4.  After pressing <ENTER>, "PASSWORD IS CHANGED" appears on display.

Privacy Policy