2-Line 900 MHz Cordless Answering Machine w/Speakerphone
(430-0681)                 Memory Operation           Faxback Doc. # 60678

You can store up to 10 numbers in the memory, then dial a stored number by 
pressing a single digit memory location number.

Storing a Number in Memory

Notes: An error tone sounds and the phone exits the storing process it you
       wait more than 20 seconds between key presses.

       Each number you store can be up to 16 digits lone.

1.  Lift the handset.

2.  Press MEM.  Both the line indicators on the handset flash.

3.  Enter the number and any tone or pause entries (see "Using Tone
    Services On a Pulse Line" in Faxback Doc. # 60677 or "Entering a
    Pause" below).

    Note: Each tone or pause entry uses one digit of memory.

4.  Repeat Steps 2 and 3, then enter the memory location number (0-9)
    where you want to store the number.  A tone sounds to indicate that
    the number is stored.

    Note: If the phone sounds five quick beeps, you have made an entry
          error and the number was not stored.  Re-enter the location
          number correctly.

5.  Repeat the steps to enter more numbers.

To replace a stored number, simply store a new one in its place.  To erase 
a number for a memory location, press MEM twice.  Then press the memory 
location number (0-9) you want to clear.  A tone sounds.

Entering a Pause

In some telephone systems, you must dial an access code (9, for example) 
and wait for a second dial tone before you can dial an outside number.  
You can store the access code with the phone number.  However, you should 
also store a pause after the access code to allow the outside line time to 
connect.  For each 2-second pause you want to enter, press REDIAL.

Dialing a Memory Number

To dial a number stored in the memory, lift the handset from the base and 
press LINE 1 or LINE 2.  The press MEM and the location number (0-9) by 
pressing a number key.  The phone automatically dials the number.

Chain-Dialing Service Numbers

For quick recall of numbers for special services (such as alternate long 
distance or bank by phone), store each group of numbers in its own memory 
location.

To use the stored special service numbers, dial the service's main number 
first.  Then, at the appropriate place in the call, press MEM and the 
number for the memory location where the additional information is stored.

Testing Stored Emergency Numbers

If you store an emergency service's number (police department, fire 
department, ambulance) and you choose to test the stored number, make the 
test call during the late evening or early morning hours to avoid peak 
demand periods.  Also, remain on the line to explain the reason for your 
call.

(EB 7/31/00)

Privacy Policy