2-Line 900-MHz Spread Spectrum Cordless Phone w/Call ID
(430-0682)                 Remote Operation           Faxback Doc. # 59764

While you are away from your home or office, you can use a touch-tone 
phone, or a pulse (rotary) phone with a pocket tone dialer (available 
through your local RadioShack store) to enter your PIN and do any of the 
following:

  Set the phone to answer or not answer calls.

  Listen to your messages.

  Record a new outgoing message.

  Erase messages.

  Monitor the room where the phone is located.

Notes: You cannot remotely operate the phone using its handset or another
       telephone on the same line as the phone. 

       You can also operate the other line that you are calling. You can
       listen to the message recorded on Line 2 making a call to Line 1's
       number.

Using The Toll-Saver

If RING TIME is set to T/S (toll-saver), (see "Setting the Number of 
Rings" in Faxback Doc. # 59760), the phone answers after two rings if you 
have new messages (ones you have not listened to).  If there are no new 
messages, the phone answers after four rings.  This gives you time to hang 
up before the phone answers so you can avoid unnecessary long-distance 
charges.

Using Remote Commands

Follow these steps to operate the phone from a remote location.

Note: If you wait more than 15 seconds between each key press, the phone
      sounds a long beep and hangs up. 

1.  Dial your phone number and wait for the phone to answer.

    If the phone is not set to answer calls, it will answer after about 10 
    rings and sound a series of beeps. 

2.  When the outgoing message begins (or the phone sounds a series of
    beeps), press #, then enter your PIN within 2 seconds. 

3.  If the PIN is correct, the phone announces the day and time, then it 
    announces the number of new and old messages.  The phone plays all new 
    messages then beeps about once every two seconds to let you know it is 
    ready to accept remote commands.

    Notes:  If the phone does not respond, try entering your pin again. If 
            you enter an incorrect PIN three times, the phone beeps and 
            hangs up.

            When the phone is in remote operation, it stops all answering 
            functions and the display on the base shows rC.  The phone 
            resumes answering functions when it is no longer in remote 
            operation if you have not turned it off. 

            The remote playback of incoming messages is limited to 4 
            minutes.  If you have more messages after 4 minutes have 
            passed, you must press # 2 again to listen to the rest of the 
            messages. 

            When using remote operation, you can only delete the current 
            message during playback.  You cannot delete all the messages 
            stored at one time. 

4.  To use a remote command, press # and (within 2 seconds) the number for 
    the command you want.

Press #
 then:           To:

  1              Repeat current message during playback.

  2              Play messages. 

  3              Skip current message during playback. 

  4              Delete current message during playback.

  5              Stop playback, recording, and room monitoring.

  6              Set the phone to answer or not answer calls. 

  7              Record or stop recording a new outgoing message. 

  8              Play the outgoing message. 

  9              Switch over to the other line (LINE 1 or LINE 2)

  0              Monitor the room where the phone is located for 15 
                 seconds.

Note:  The remote operation stops when someone picks up the handset or any
       phone on the same phone line.

(BR EB 5/19/00)

Privacy Policy