Quick Hang Up Module w/User Programmable Voice Message
(430-0147)                 Installation               Faxback Doc. # 57497

Read This Before Installation

We designed your Quick Hang Up Module to conform to federal regulations, 
and you can connect it to most phone lines.  However, each device you 
connect to the phone line draws power from the line.  We refer to this 
power draw as the device's ringer equivalence number, or REN.  The REN is 
on the bottom of your Quick Hang Up Module.

If you use more than one phone or other device on the line, add all the 
RENs.  If the total is more than five, your phones might not ring.  In 
rural areas, a total REN of three might impair ringer operation.  If 
ringer operation is impaired, remove a device from the line.

WARNING:  To reduce the risk of fire or shock hazard, do not expose this
          product to rain or moisture.

CAUTION:  To reduce the risk of electric shock, do not remove cover or
          back.  No user-serviceable parts inside.  Refer servicing to
          qualified personnel.

The Quick Hang Up Module has been tested and found to comply with all 
applicable standards.

FCC Statement

Your Quick Hang Up Module complies with Part 68 of FCC Rules.  You must, 
upon request, provide the FCC registration number and the REN to your 
phone company.  Both numbers are on the bottom of the module.

Note:  You must not connect your module to:

         Coin-operated systems.

         Party-line systems.

         Most electronic key phone systems.

Installing a Battery

Your Quick Hang Up Module requires one 9V battery (not supplied) for 
power.  For the best performance, we recommend an alkaline battery such as 
RadioShack Cat. No. 23-553.

CAUTION:  Use only a fresh battery of the required size and recommended
          type.

1.  Remove the screw on the battery compartment cover with a screwdriver,
    then lift the cover to remove it.

2.  Snap the battery contacts onto the battery terminals, then place the
    battery in the compartment.

3.  Replace the cover and secure it with the screw.

If the indicator does not light or becomes dim when you use the module, 
replace the battery.

CAUTIONS:  Always remove an old or weak battery.  Batteries can leak
           chemicals that can destroy electronic parts.

           Dispose of old batteries promptly and properly.  Do not burn or
           bury them.

Connecting to the Telephone Line

Unplug the modular cord from your phone, and plug it into the LINE jack on 
the Quick Hang Up Module.  Then plug the module's cord into the phone's 
jack.

If your phone is connected to another telephone device, such as an 
answering machine or Caller ID system, simply connect the Quick Hang Up 
Module between the device and your phone.

(EB 11/11/99)