CT-601 Lightweight Flip-Style 75-Memory Cellular Phone
(170-1106)                 Addendum                   Faxback Doc. # 52210

The section "Charging the Battery" in Faxback Doc. # 52142 incorrectly 
states that a desktop charging stand is supplied with the CT-601.  The 
referenced stand is actually optional, and is available separately through 
your local RadioShack store.

The "Charging the Battery" section should read as follows:

Once you install the battery on the phone, follow these steps to charge or 
recharge the battery using a desktop charging stand (optional accessory) 
available through your local RadioShack store.

1.  Insert the charger's barrel plug into the jack on the back of the
    desktop charging stand, then set the phone on the stand with the
    phone's keypad facing out.

    Or, to charge the phone without the stand (so you can use the phone
    while it is charging, for example), insert the charger's barrel plug
    into the jack on the bottom of the phone.

2.  Connect the charger's AC plug to a standard AC outlet.  The battery
    charge indicator bar appears and begins to scroll.

Notes:  For the fastest charging, be sure the phone is turned off during
        charging.

        If you use the phone while it is charging, charging takes longer.

        If the battery is too hot or cold, charging stops until the
        battery temperature returns to normal.

        With a new or completely discharged battery, the phone may take up
        to 45 minutes to show that charging is in progress.

3.  The battery indicator bar stops scrolling when the battery is fully
    charged.  Disconnect the charger from the AC outlet and the phone.

Using the supplied battery (fully charged), you have about 2 hours and 45 
minutes of talk time or 40 hours of standby time.

Note:  Check with your local RadioShack store for an optional battery
       charger stand.

(EB 4/27/99)