Fujitsu Portable Cellular Telephone
(170-1203)                 Battery                    Faxback Doc. # 52108

About the Battery

Attaching the Battery

1.  Position battery with bottom edge of battery inserted into bottom edge
    of phone on the back of the phone.

2.  Press top of battery towards phone until battery snaps into place.

Removing the Battery

1.  Press lock tab in.

2.  Using tabs on sides of battery, pull top edge of battery away from
    phone.

3.  Lift battery away from unit.

Charging the Battery

1.  With battery in place, connect 9 volt AC Adapter cord to base of
    phone.  Batteries are shipped from the factory in a discharged state.
    Best performance is achieved after battery is fully charged and fully
    discharged for three cycles.

2.  Connect 9 volt AC Adapter plug to any standard 110 volt AC outlet.
    Trickle charging begins.  Display shows "Charging". A fully discharged
    Extra Talk Time NiCd battery charges in approximately 10 hours.

    A fully discharged Ultra Light NiCd battery charges in approximately 6
    hours.  Do not let the battery charge for more than 24 hours.

Note:  Battery Memory Effect of Nickel Cadmium (NiCd) Batteries

       Repeated partial charging and discharging of rechargeable Nickel
       Cadmium (NiCd) batteries results in a "memory" that reduces battery
       charging capability.  To erase "memory effect", fully discharge the
       battery as follows:  operate the phone until the battery alarm
       sounds; leave phone in standby mode (turned on) until phone powers
       itself off.  When phone no longer responds to [ON/OFF] key, battery
       is fully discharged.  Follow instructions for charging the battery.

                            ------- Nickel Cadmium (NiCd) ------

                         Talk Time    Standby    Trickle Charging Time
Ultra Light Battery        70 min      9 hrs            6 hrs
Extra Talk Time Battery   120 min     14 hrs           10 hrs

                           ---- Nickel Metal Hydride (NiMH) ----

                         Talk Time    Standby    Trickle Charging Time
Ultra Light Battery        90 min     12 hrs            8 hrs
Extra Talk Time Battery   140 min     18 hrs           12 hrs

All times are approximate.

Checking the Battery Meter

1.  Quickly press [ON/OFF].  Display current battery voltage from 0 (low)
    to 5 (high) bars.

When you Hear the Low Battery Alert

1.  Replace battery immediately.  Your phone allows you to maintain a call
    for approximately 5 seconds while changing batteries.

    Your phone will audibly alert you to a low battery condition during
    call in progress or stand-by mode.  During a call, you typically have
    up to 5 seconds to replace the battery without dropping the
    connection.

2.  Recharge battery.  Whenever possible, allow NiCd batteries to fully
    discharge before recharging.  Repeated partial recharging may reduce
    battery capacity.

(EB 4/14/99)