ET-548 25-Channel Cordless Headset Telephone
(430-1048A)                Troubleshooting            Faxback Doc. # 51344

We do not expect you to have any problems with your phone, but if you do, 
the following suggestions might help.  If you still have problems, take 
the phone to your local RadioShack store for assistance.

SYMPTOM                    SUGGESTION

Interference is severe.    Move the remote keypad closer to the base.

                           Keep the base and remote keypad away from
                           interference sources such as computers, radio
                           controlled toys, wireless microphones, wireless
                           alarm systems, wireless intercoms and room
                           monitors, fluorescent lights, and electrical
                           appliances.

                           Turn off the interfering device.

                           Hang up and redial the number.

The range decreases.       Fully extend the base's antenna and raise it to
                           a vertical position.

                           Ensure the antenna is not touching a metal
                           surface.

                           Recharge the remote keypad battery pack.

The volume level drops     Hang up the second phone.
or you hear unusual
sounds when someone picks
up another phone on the
same line.

The phone does not work.   Ensure POWER is set to ON.

                           Move the remote keypad closer to the base.

                           Fully extend the base's antenna and raise it to
                           a vertical position.

                           Ensure the phone's modular cord and the AC
                           adapter are correctly and securely connected.

                           Recharge the remote keypad's battery pack.  (If
                           the battery power is too low, the TALK/LOW BATT
                           indicator does not light.)

                           Reset the security access-protection code by
                           placing the remote keypad in the cradle with
                           POWER set to ON, disconnect AC power and then
                           reconnect AC power.

If the problem persists, disconnect the phone.  If other phones on the 
same line work properly, the fault is in this phone or its installation.  
If you cannot locate the problem, take your phone to your local RadioShack
store for assistance.

(EB 2/5/99)