ET-687 2-Line 900 MHz Digital Spread Spec. Cordless Phone
(430-0687) Care and Maintenance Faxback Doc. # 51229
Your RadioShack ET-687 Two-Line 900 MHz Digital Spread Spectrum Cordless
Telephone is an example of superior design and craftsmanship. The
following suggestions will help you care for your ET-687 so you can enjoy
it for years.
Keep the ET-687 dry. If it gets wet, wipe it dry immediately. Liquids
might contain minerals that can corrode the electronic circuits.
User and store the ET-687 only in normal temperature environments.
Temperature extremes can shorten the life of electronic devices, damage
battery packs, and distort or melt plastic parts.
Keep the ET-687 away from dust and dirt, which can cause premature wear
of parts.
Handle the ET-687 gently and carefully. Dropping it can damage circuit
boards and cases and can cause the ET-687 to work improperly.
Use only a battery pack of the required size and recommended type.
Batteries can leak chemicals that damage your ET-687's electronic parts.
Wipe the ET-687 with a damp cloth occasionally to keep it looking new.
Do not use harsh chemicals, cleaning solvents, or strong detergents to
clean the ET-687.
Modifying or tampering with the ET-687's internal components can cause a
malfunction and might invalidate its warranty and void your FCC
authorization to operate it. If your ET-687 is not performing as it
should, take it to your local RadioShack store for assistance. If the
trouble is affecting the telephone lines, the phone company can ask you to
disconnect your ET-687 until you have resolved the problem.
Replacing The Battery Pack
If you follow the instructions in "Connecting and Charging the Battery
Pack" in Faxback Doc. # 51226, the battery pack should last about one
year. If the battery pack does not hold a charge for more than 2 hours
after an overnight charge, replace it with a new 3.6-volt, 600 mAh battery
pack with a connector that fits the socket in the battery compartment.
You can order a replacement battery pack through your local RadioShack
store.
Install the new battery pack as described below, then charge it for about
24 hours.
Note: To avoid losing memory numbers, try to install and begin charging
the new battery pack within 1 minute.
1. Press down and slide off the battery pack compartment cover.
2. Unfasten the plastic retainer strap and lift the battery pack out of
the compartment, then gently pull on the battery connector to
disconnect it.
3. Insert the new battery pack's connector into the socket in the
compartment, place the battery pack into the compartment, and refasten
the retainer strap.
4. Replace the cover.
CAUTIONS: You must use a replacement battery pack of the same size and
type.
Do not dispose of the battery pack in a fire because it might
explode.
Do not open or mutilate the battery pack.
Be careful not to short the battery pack by touching the
connector's pins with conducting materials, such as rings,
bracelets, and keys. The battery pack or conductor might
overheat and burn.
If you have trouble replacing the battery pack, take the phone to your
local RadioShack store for assistance.
IMPORTANT: This product contains a rechargeable nickel-cadmium battery
pack. At the end of the battery pack's useful life, it must
be recycled or disposed of properly. Contact your local,
county, or state hazardous waste management authorities for
information on recycling or disposal programs in your area.
Some options that might be available are: municipal curb-side
collection, drop-off boxes at retailers such as your local
RadioShack store, recycling collection centers, and mail-back
programs.
The FCC Wants You to Know
In the unlikely event that your phone causes problems on the phone line,
the phone company can temporarily discontinue your service. If this
happens, the phone company attempts to notify you in advance. If advance
notice is not practical, the phone company notifies you as soon as
possible and advises you of your right to file a complaint with the FCC.
Also, the phone company can make changes to its lines, equipment,
operations, or procedures that could affect the operation of this
telephone. The telephone company notifies you of these changes in
advance, so you can take the necessary steps to prevent interruption of
your telephone service.
Your phone might cause TV or radio interference even when it is operating
properly. To determine whether your phone is causing the interference,
turn off your phone. If the interference goes away, your phone is causing
it. Try to eliminate the interference by:
moving your phone away from the receiver.
connecting your phone to an AC outlet that is on a different electrical
circuit from the receiver.
contacting your local RadioShack store for help.
If you cannot eliminate the interference, the FCC requires that you stop
using your phone.
Some cordless telephones operate on frequencies that might cause
interference to nearby TVs and VCRs. To minimize or prevent such
interference, the base of the cordless telephone should not be placed near
or on top of a TV or VCR.
Lightning
Your telephone has built-in lightning protection to reduce the risk of
damage from surges in telephone line and power line current. This
lightning protection meets or exceeds FCC requirements. However,
lightning striking the telephone or power lines can damage your telephone.
Lightning damage is not common. Nevertheless, if you live in an area that
has severe electrical storms, we suggest that you unplug your phone during
storms to reduce the possibility of damage.
(EB 2/2/99)
Privacy Policy