Motorola Model 13241  3-Watt Portfolio Phone
(170-1218)                 Assembly                   Faxback Doc. # 46620

Carry Phone Assembly Procedure

The items included with your Motorola cellular mobile carry phone are
shown in Faxback Doc. # 46672.  The following procedure will guide you
through the assembly of your carry phone.

Step 1       Remove the cellular telephone transceiver and handset from
             the packing box.

Step 2       Remove the carrying bag from the packing box.  Open the
             carrying bag and remove the cigarette lighter connector
             assembly, rubber o-ring, thumbscrews, antenna, battery (if
             included) and battery charger (if included).

Step 3       Carefully connect the 25-pin connector (of the cigarette
             lighter connector assembly) to the front of the transceiver
             and hand tighten the two thumbscrews into the threaded holes
             at the end of the transceiver. 

Step 4       Locate the antenna port on the transceiver front.  Find the
             rubber o-ring and slide it on the port.  Screw the antenna
             tightly on the port so that it compresses the o-ring.  This
             will prevent the antenna from loosening.  Align the antenna
             vertically along the power connector assembly. 

Step 5       Slide the transceiver into the carrying case compartment with
             the antenna positioned along the outside of the case.

Step 6       Place the top of the antenna inside the elastic loop. Zip the
             compartment closed. Be sure to connect the cigarette lighter
             plug to the cigarette lighter socket on your vehicle dashboard
             when you are ready to use your phone.

             Note:  Steps 7-11 should be followed if your carry phone is
                    equipped with a battery.

Step 7       Charge your battery for 14 hours or overnight using the AC
             charger before attempting to use the cellular telephone.

Step 8       Orient the battery so that the cigarette lighter socket is
             farthest from the end of the carrying case with the antenna.
             Carefully connect the power connector by inserting it into
             the cigarette lighter socket of the battery.

Step 9       Slide the battery and transceiver into the carrying case
             compartment with the antenna positioned along the outside of
             the case.

Step 10      Plug the handset coil cord connector into the modular
             connector socket on the side of the transceiver.  Move the
             hang up cup aside to allow room to insert the connector.
 
Step  11     Place the handset into the hang up cup.

(BR/eb 3/2/98)

Privacy Policy