SP-511 25-Channel Cordless Telephone
(430-5511)                 Installation               Faxback Doc. # 44305


These instructions are for both table and wall plate installation.

1.  Choose a location near an electrical outlet and a telephone jack.
    This phone requires a modular telephone jack and a standard electrical
    outlet (110v AC).

2.  Install the handset battery pack.

3.  Set the handset ringer switch.  Set RINGER on the side of the handset
    to ON so the handset will ring.  When this switch is set to OFF, the
    handset will not ring.

NOTE:  If you set RINGER to OFF, the handset battery will last longer.
       However, when RINGER is set to OFF, you will always need to press
       PHONE to answer a call, even when you lift the handset from the
       base.

4.  Connect the telephone line cord.  Plug one end of the supplied 
    telephone line cord into the jack on the back of the base.  (If you are
    wall mounting the phone, wrap the excess cord around the posts in the
    groove on the bottom of the base.)  Plug the other end of the line cord
    into a modular phone jack.  Make sure the plug snaps firmly in place.

5.  Mount the base on the wall plate (WALL MOUNTING ONLY).  Hold the base
    so the mounting studs on the wall plate fit into the holes on the 
    bottom of the base.  Slide the base down onto the studs until it locks
    into place.

6.  Raise the antenna on the base so it is vertical.

7.  Connect the power cord.  Plug the power cord's barrel plug into POWER
    on the back of the base.  Plug the AC adapter on the power cord into an
    electrical outlet.

8.  Charge the handset battery pack for four hours before use.  Place the
    handset face down on the base.  The CHARGING light on the base turns
    on, indicating that the handset is in the right position to charge the
    battery pack.

9.  Once the battery pack is charged, check for a dial tone.  Pick up the
    handset.  Check for a dial tone by pressing PHONE; the PHONE light
    should turn on and you should hear a dial tone.

10.  Set the dial mode.  If you have touch-tone service, the phone is ready
     to use as soon as the battery is charged.  If you have dial pulse 
     (rotary) service, you'll need to set the dial mode.  Press PHONE 
     PROG/MEM # # # 3.  To return to touch-tone dialing, press PHONE 
     PROG/MEM # # # 8.

CAUTION:  Use only the AC power adapter supplied with this telephone.

(km-09/18/97)