CT-460 Hands-Free Cordless Telephone
(430-1060)                 Installation               Faxback Doc. # 38246

Attaching the Telephone Line Cord and AC Adapter

Connect the telephone line cord to the telephone jacks in the base unit
and wall.

Connect one end of the AC adapter to the base unit and plug the other end
into a standard electrical outlet (110 VAC, 60 Hz).

Setting the Ringer Controls

Adjust the ringer on the base unit to the desired volume level (i.e., OFF,
LOW, or HIGH).

Adjust the ringer on the remote pack to the desired setting (i.e., ON or
OFF).

Even with the remote pack ringer turned to OFF, you are able to make or
receive calls.  However, in this mode, you will only be aware of an inbound
call if you are able to hear your base unit ringer.

Setting the Tone/Pulse Switch

Adjust the tone/pulse switch on the base unit to reflect the service
offered by your phone company.

If touch tone dialing is supported, set the switch to T.  If rotary dialing
is supported, set the switch to P.

Installing and Charging the Battery Pack

Open the battery compartment of the remote pack and plug the battery pack
lead into the remote pack connector.  Place the battery pack inside the
remote unit and close the battery compartment.

Place the remote pack into the cradle of the base unit and verify that the
charge indicator on the base unit has turned on.  Before using the CT-460
phone for the first time, let the battery pack charge for 12 hours.

During the course of operation, recharge the battery pack as needed (see the
Remote Pack Operating Procedures section regarding low battery indicators).

Attaching a Noise Canceling Headset

Two noise canceling headsets are provided as options: an earbud style and
a headband style.  Based on your wearing preferences, select one headset
style and plug its connector into the headset jack on the remote pack.

Wearing the Remote Pack

The remote pack may be worn in a shirt pocket, on a belt or around the neck.

To wear the remote pack on a belt attach the holster belt clip to your belt.

Snap the remote pack in and out of holster belt clip without removing the
belt clip.

To move the remote pack out of the way (e.g., before sitting), rotate the
remote pack and belt clip.

To wear the remote pack around your neck, attach the neck strap to the
holster belt clip.

Snap the remote pack into the belt clip and place the neck strap around
your neck.  Adjust the length of the strap as appropriate.

Installing the Wall Mount Option

If mounting the CT-460 base unit on the wall is desired, snap the tabs of
the optional wall mount into the corresponding slots of the base unit.

Mount the base unit and its wall mount onto a telephone line faceplate or
other wall attachment.

The headset holder attached to the wall mount may be used to store either
of the noise canceling headset tops when not in use.

Positioning the Base Unit Antenna

Fully extend the base unit antenna.

Whether the base unit is desk mounted or wall mounted, adjust the base unit
antenna so that it is positioned vertically.


(br/EB 12/11/96)

Privacy Policy