ET-549/25-Channel Cordless Telephone with 10-Number Memory
(430-1049)                 Preparation                Faxback Doc. #  37019

SETTING THE DIALING MODE

Set P* *T on the back of the base for the type of service you have.  If you
are not sure which type you have, do this test.

1.  Set P* *T to T (tone).

2.  Lift the handset and listen for a dial tone.

3.  Press any number other than 0.

    NOTE:  If your phone system requires that you dial an access code (9,
           for example) before you dial an outside number, do not press the
           access code either.

           If the dial tone stops, you have touch-tone service. Leave P* *T
           set to T (tone).
   
           If the dial tone continues, you have pulse service. Set P* *T to
           P (pulse).

SETTING THE RINGER TONE AND VOLUME

You can select one of four different ringer/tone volume settings when the
phone is not in use.

1.  Lift the handset.  If you hear a dial tone, press TALK to turn it off.

2.  Press RINGER.  The phone sounds the current ringer tone and volume.

3.  Repeatedly press RINGER until you hear the desired ringer tone and
    volume.

    Each time you press RINGER, the ringer changes in the following order:

    |> High-volume "chirping"
    |    |
    |    |> Low-volume "chirping"
    |       |
    |       |> High-volume "warbling"
    |          |
    |          |> Low-volume "warbling"
    |______________|


(YO/EB 11/7/96)

Privacy Policy