NOKIA 101 Cellular Phone
(170-1095)                 NAM Programming            Faxback Doc. # 35205

NAM Programming Instructions

The Nokia 101 cellular telephone is similar in operation to our CT-350/351/
353 (Cat. Nos. 17-1060/1061/1063).  Follow these steps to program the Nokia
101.

For Step 7, fill in the parameters (blanks) as you will use them in your
store:

__ __ __ __ __ * __ * __ *33 __ * __ __ * __ __

NOTE:  Be sure to fill in all blanks, inserting leading zeros if necessary.

1.  To enter the Program Mode, type:  *3001#12345 STO 00
    The phone responds: STORE NOT DONE

2.  To program the user's phone number, type:  RCL 0 2
    
    The phone responds with:  1111111111  or a previously programmed phone
    number.

3.  Press and hold CLR until the display is empty.

4.  Type in the customer's cellular phone number, then STO 0 2.
    For example:  STO 0 2

    The phone responds with: REPLACE CONTENT?

5.  Press: STO

    The phone responds with: STORED

6.  Now enter the carrier parameters by typing: RCL 0 3

    The phone responds with:  38*1*1*334*15*15

7.  Press and hold CLR until the display is empty.  Type in the cellular
    carrier's parameters, followed by STO 0 3

    For example:  00038*1*1*334*05*10 STO 03

    where

      00038 = Home ID or system ID
      1 = Access method
      1 = Local control option
      (333 = "A" carrier)
      (334 = "B" carrier
      05 = Overload class
      10 = Group ID

    The phone responds with: REPLACE CONTENT?

8.  Press STO
    The phone responds with: STORED

9.  To check or change the Lock Code, type:  RCL 0 1

    The phone responds with:  911#* 911#0* 1234

    NOTE:  Do not confuse the "Lock Code" with the "Security Code".  The
           Lock Code is ONLY 4 digits long and is completely different from
           the Security Code which is 5 digits long (12345).  In addition,
           this step varies depending on the model of phone.

10. To change the Lock Code, type:  CLR CLR CLR CLR

11. Type the new four digit Lock Code, then type:  STO 0 1

    The phone responds with: REPLACE CONTENT?

12. Press: STO

    The phone responds with: STORED

13.  Exit the NAM programming mode by turning the power off.

NOTE: Wait at least two hours after receiving the cellular telephone number
      from the cellular carrier before trying to make or receive a call.
      After powering the phone up again, you will receive NAM ERROR if
      errors were made while programming.


(EB 10/30/96)