ET-547/ET-557 Cordless Telephone
(430-1047/57) Troubleshooting Faxback Doc. # 19948
We do not expect you to have any problems with your phone, but if you do,
the following guidelines might help. If you still have problems, take the
phone to your local RadioShack store for assistance.
PROBLEM REMEDY
Low volume or unusual sounds. Someone has picked up another phone on
the same line. Hang up the other phone.
Severe noise interference. Press CHANNEL to change the channel.
Keep the handset away from computers,
remote control toys, wireless
microphones, alarm systems, intercoms,
room monitors, fluorescent lights, and
electrical appliances.
Move to another location or turn off
the source of interference.
The phone cannot be operated Fully extend the base's antenna in a
at a useful distance from the fully vertical position.
base because the signal becomes
weak or noisy (handset's range Return the handset to the cradle, and
has decreased). recharge the battery.
Be sure neither antenna is touching a
metal surface.
The phone does not work or Be sure the base's phone line cord and
works poorly. AC adapter are correctly and securely
connected, and the battery is charged.
The handset battery does not Check the charging contacts on the
charge. handset and base. If they are dirty,
clean them with a pencil eraser.
Be sure the battery is connected
correctly.
Handset doesn't ring or The battery pack might be weak. Charge
receive a page. the battery on the base for 15-24 hours.
Set RINGER/ON/OFF on the handset to ON.
Extend the base's antenna vertically.
Move closer to the base.
Place the base away from noise sources.
Return the handset to the cradle to
reset it.
The handset stops working or Move the handset closer to the
works poorly during a call. base.
Be sure the handset's battery is
charged. (If the battery power is too
low, it does not have enough power to
light the TALK/BATT LOW indicator).
Fully extend the base's antenna, and
place it in a fully vertical position.
Make sure that the charging contacts on
the handset and base are clean.
The call is too noisy. Change channels or hang up and redial
the number.
If the base loses power for Re-establish communication between the
over an hour while the handset and the base. Remove the
handset is off of it, the handset from the base (if it is on the
code might change. base). Restore power to the base, then
place the handset back on the base. The
CHARGE indicator lights, indicating that
the code is set again.
If you still have problems, disconnect the phone. If other phones on the
same line work properly, the fault is in this phone or its installation.
If you cannot find the problem, take your phone to your local RadioShack
store for assistance.
(RF/SP/all-06/27/96)
Privacy Policy