Crystal-Controlled  (120-0244)      Operation          Faxback Doc. # 7994
Pocket Weatheradio

BATTERY INSTALLATION

You need a 9-volt battery to power your Weatheradio.  We recommend an
alkaline battery, such as Radio Shack Cat. No. 23-553.  Follow these steps
to install the battery.

1.  Remove the battery compartment cover by pressing down on the cover and
    sliding it in the direction of the arrow.

2.  Snap the 9-volt battery onto the battery connector and place it in the
    compartment.

3.  Replace the compartment cover.

Caution:  Remove the battery if you do not plan to use your Weatheradio
          for a week or more.  Weak or dead batteries can leak chemicals
          that might damage the radio.

Follow these steps to operate the radio.

1.  Extend the telescoping antenna to its full length.  Do not try to bend
    or swivel the antenna.

2.  Turn VOLUME clockwise until it clicks to turn on the radio.

3.  Set FREQUENCY to the position that results in the cleanest reception
    (A, B, or C).

4.  Adjust VOLUME to a comfortable listening level.

    Note:  If the signal is broken or noisy, move the radio around to find
           the location that provides the clearest reception.  If
           reception is still not clear, try placing the radio near an
           outside wall or window.

5.  To turn off the radio, turn VOLUME counterclockwise until it clicks.

    Notes:  If you are unable to receive the weather station signal,
            contact the local National Weather Service office to verify
            that the station is on the air.

            Severe cold reduces your radio's sensitivity and the battery's
            power.  If you use the radio in a cold place, keep it inside
            your pocket.

(br/all-12/01/94)

Privacy Policy