SAME Alert Weatheradio w/AM/FM Atomic Clock Radio
(120-0253)                 Operation                  Faxback Doc. # 63415

Listening to a Weather Broadcast

To listen to a weather broadcast, press WEATHER/SNOOZE, then adjust VOLUME 
to the desired listening level.  To turn off the weather broadcast, press 
WEATHER/SNOOZE again.

Using the Alarms

You can set two independent alarms to sound.

1.  Hold down ALARM1 or ALARM2 until the display flashes.

2.  Repeatedly press or hold down OK/HR until the display shows the
    correct alarm hour setting.

3.  Repeatedly press or hold down SCROLL/MIN until the display shows the
    correct alarm minute setting.  The display flashes.

4.  Press ALARM1 or ALARM2 again to store the alarm time setting.  ALARM
    appears, the Weatheradio beeps, and the radio turns on.

5.  If the radio is not already set to the band you want to use (AM or
    FM), select the desired band by pressing AM/FM/OFF.  AM and an AM
    frequency appear.  To select the FM band, press AM/FM/OFF again.

    Within 30 seconds, if you do not press any key, the Weatheradio will
    quit alarm time setup mode automatically and save all of the alarm
    settings.

6.  Press SEEK to automatically search for the frequency you want in the
    selected band.  When you hear the frequency you want, press ALARM1 or
    ALARM2 to store it.

7.  to wake to the alarm sound, slide AUTO/ALARM to ALARM.  At the preset
    alarm time, the alarm sounds. To stop it sooner, press ALARM1 or 
    ALARM2.

8.  To wake to the radio, slide AUTO/ALARM to AUTO.  At the preset time,
    the radio turns on.  to stop it sooner, press ALARM1 or ALARM2.

9.  To cancel the alarms, repeatedly press ALARM1 or ALARM2 until ALARM1
    OFF or ALARM2 OFF appears.

Using Snooze

To temporarily silence the alarm (or the radio), press WEATHER/SNOOZE.  
This silences the alarm (or the radio) for about 10 minutes.  You can 
press WEATHER/SNOOZE as many times as you like.

Using the Sleep Timer

You can set the radio to play for up to 2 hours then automatically turn 
off.

1.  Press AM/FM/OFF to turn on the radio.

2.  Press SLEEP.  SLP 120M flashes.

3.  Repeatedly press SLEEP to reduce the sleep time in 10 minute
    intervals.

    The radio plays for the set length of time then automatically turns
    off.  To turn off the sleep timer, repeatedly press SLEEP until SLP
    -- -- -- M flashes, or press WEATHER/SNOOZE to switch to a weather
    broadcast for weather information.

Note: When the Weatheradio receives a weather warning message, it turns
      off the radio if it is playing and switches to the weather broadcast

Using the Radio

1.  To turn on the radio, press AM/FM/OFF.  AM and an AM frequency appear.
    To select the FM band, press AM/FM/OFF again.

2.  Press SEEK to automatically search for the next strong frequency.
    Press SEEK again to stop the search.  Hold down OK/HR to tune to
    higher frequencies or SCROLL/MIN to tune to lower frequencies.

3.  Press CLOCK to view the time.  Press AM/FM/OFF to view the frequency
    the radio is tuned to when the sleep time appears.

    Notes: If the displayed frequency disappears, press AM/FM/OFF to
           display it again.

           If the radio is on, press WEATHER/SNOOZE to turn off the radio
           and switch to the weather broadcast.

           If the weather broadcast is on, press AM/FM/OFF to turn off the
           weather broadcast and switch to the AM band.

           If the radio is on and the Weatheradio receives a weather
           warning message, the Weatheradio automatically turns off the
           radio and switches to the weather broadcast. If the Weatheradio
           receives an "End of Message" signal or 5 minutes elapse without
           a weather signal, the Weatheradio switches back to the radio
           broadcast.

          If the radio is on and the Weatheradio receives a weather
          warning expiration message, the Weatheradio automatically
          switches back to the radio broadcast and displays the frequency.

4.  To turn off the radio, press AM/FM/OFF twice (if the AM band is
    selected) or once (if the FM band is selected).  Or, press WEATHER/
    SNOOZE to turn off the radio and switch to the weather broadcast.

Using the Memory

You can store up to five AM and five FM stations into the Weatheradio's 
memory.  Once you select the desired station, hold down the RADIO MEMORY 
button (1-5) you want to use to store it, for about 1 second.  A beep 
sounds and MEMORY and the button number appear, and the station is stored.

Notes: If the displayed frequency disappears, press AM/FM/OFF to display
       it again.

       The RADIO MEMORY buttons do not work when the radio is playing and
       the clock appears. Press AM/FM/OFF to use the RADIO MEMORY buttons.

Using Key Lock

To avoid accidentally changing the radio's settings, slide KEY LOCK on the 
back of the Weatheradio to the left.  To unlock the keys, slide KEY LOCK 
to the right.

(EB 11/15/00)

Privacy Policy