Extra Remote Sensor to 63-1030
(630-1031)                 Operation                  Faxback Doc. # 61518

Once you install batteries in the remote sensor, it displays the current 
temperature, humidity, and the channel number it is set to, and starts 
transmitting signals (to Cat. No. 63-1030 system's main unit) about every 
41 seconds.

Changing the Display Channel

The Cat. No. 63-1030 system's main unit can display information for up to 
three different remote sensors.

Set CHANNEL 1/2/3 inside this remote sensor's battery compartment to a 
different setting than all other remote sensors you are using.  Then press 
RESET using a pointed object (such as a straightened paper clip).

Note: If you set two or more remote sensors to use the same channel, the
      main unit displays temperature and humidity information for the
      remote sensor's signal it received first.

Changing the Degrees Format

To change the displayed degree format, set C/F degrees inside the remote 
sensor's battery compartment to the desired setting.

Resetting the Sensor

If the remote sensor stops operating properly, use a pointed object (such 
as a straightened paper clip) to press RESET.  This resets the displayed 
temperature and humidity readings and re-initializes the sensor's 
transmitter.

(EB 9/5/00)

Privacy Policy