Indoor Humidity Gauge Thermometer
(630-1013)                 Preparation                Faxback Doc. # 58416

Installing Batteries

Your thermometer requires two AAA batteries (not supplied) for power.  For 
the best performance and longest life, we recommend RadioShack alkaline 
batteries.

CAUTIONS:  Use only fresh batteries of the required size and recommended
           type.

           Do not mix old and new batteries, different types of batteries
           (standard, alkaline, or rechargeable) or rechargeable batteries
           of different capacities.

Follow these steps to install batteries.

1.  Slide off the mounting plate and battery cover.

2.  Insert batteries according to the polarity symbols (+ and -).

3.  Replace the cover and mounting plate.

When the display dims or the thermometer stops operating properly, replace 
the batteries.

WARNING:  Dispose of old batteries promptly and properly.  Do not burn or
          bury them.

Setting to Fahrenheit or Celsius

To display the temperature in Fahrenheit, slide open the battery 
compartment cover and set degrees C/degrees F to degrees F.  To display 
the temperature in Celsius, set degrees C/degrees F to degrees C.

Mounting the Thermometer

You can use the adhesive tape on the back of the mounting bracket, or 
screws (not supplied), to mount the thermometer on the wall. Or you can 
use the built-in stand to set it on a flat surface.

Using the Adhesive Tape

  Remove the tape's backing.

  Press the mounting plate against a wall.

  Side the thermometer into the plate.

Using Screws

  Drive two screws into the wall through the mounting plate.

  Slide the thermometer into the plate.

Using the Stand

  Remove the mounting plate.

  Lift the stand.

  Set the thermometer on a flat surface.

(EB 2/2/00)