Wireless Remote Thermometer Sensor
(630-1027)                 Operation                  Faxback Doc. # 51062

Once you install batteries in the remote sensor, it displays the current
temperature and the channel number it is set to, and starts transmitting
signals (to your Cat. No. 63-1026 system's main unit) about every 30
seconds.
                        _____________________________
                       |       _ _   _ _    _ _      |
  Channel Number _     |      |   |     |  |         |
                  \    |  _   |_ _|  _ _|  |_ _ o _  |
                   \__>|  _|  |   | |      |   | |_  |
                       | |_   |_ _| |_ _  o|_ _| |   |
                       |_____________________________|
                                     /\
                                      \
                                       \_Current Temperature
Changing The Display Channel

The Cat. No. 63-1026 system's main unit can display information for up to
three different remote sensors.

Set CHANNEL 1/2/3 inside this remote sensor's battery compartment to a
different setting than all other remote sensors you are using.  Then press
RESET using a pointed object (such as a straightened paper clip).

Note:  If you set two or more remote sensors to use the same channel, the
       main unit displays temperature information for the remote sensor's
       signal it received first.

Changing The Degree Format

To change the degree format displayed on the remote sensor, set C degrees/
F degrees inside the remote sensor's battery compartment to the desired
setting.

Resetting The System

If the remote sensor stops operating properly, use a pointed object (such
as a straightened paper clip) to press RESET.  This resets the displayed
temperature and reinitializes the sensor's transmitter.

(EB 1/5/99)