Indoor/Outdoor Thermometer
(630-1026)                 Troubleshooting            Faxback Doc. # 50952

Manually Searching For A Signal

If the main unit displays - - . - instead of a temperature or it
continuously displays a temperature different than that displayed on the
selected channel's remote sensor, this means the main unit has stopped
receiving a signal from the sensor.  Press CHANNEL and MEM at the same
time on the main unit to have it manually search for a signal.

If the main unit still does not operate properly, try placing it or the
remove sensor in a different location or resetting the system (see
"Resetting The System", below).

Resetting The System

If the main unit stops operating properly (and you have tried manually
searching for a signal) use a pointed object (such as a straightened paper
clip) to press RESET.  This resets all display elements and temperature
settings.

If the remote sensor stops operating properly (and you have tried manually
searching for a signal) use a pointed object (such as a straightened paper
clip) to press RESET inside the remote sensor's battery compartment.  This
resets the displayed temperature and reinitializes the sensor's
transmitter.

(EB 12/28/98)