LCD Dual Display Indoor/Outdoor Thermometer with Memory
(630-1020)                 Operation                  Faxback Doc. # 37482

Your indoor/outdoor thermometer displays both the indoor and outdoor
temperature as soon as you install the battery.  The temperature updates
every 10 seconds, so it might take several minutes for the thermometer to
register a rapid temperature change.

The outdoor temperature displays at the top and the indoor temperature
displays at the bottom of the LCD.

Reading the Maximum and Minimum Temperatures

Follow these steps to read the maximum or minimum temperatures recorded
since you last reset the thermometer.

1.  Press MIN or MAX.  The minimum or maximum temperatures recorded and
    MEM appear on the display.

2.  Press MIN or MAX again.  MIN or MAX and MEM disappear from the
    display.  The current temperatures appear on the display.

Notes:  Outdoor measurements - when the temperature is below -58 degrees
        F, LLL appears on the display.  When the temperature is above 158
        degrees F, HHH appears on the display.

        Indoor Measurements - When the temperature is below 23 degrees F,
        the reading appears on the display, but it gradually fades out.
        When the temperature is above 122 degrees F, the LCD blacks out.

When the temperature returns to the measurement range, the LCD display
returns to its normal state.

Clearing the Maximum and Minimum Temperatures

Press RESET to clear the maximum and minimum temperatures.  MAX, MIN, MEM,
and 188 degrees F appear on the display for about 3 seconds.  Then the
current readings appear on the display.

(EB 9/1/98)