Indoor/Outdoor Thermometer
(630-1009)                 Installation               Faxback Doc. # 37272

Mounting 

You can mount the thermometer on a wall or prop it up on any flat surface
using its built-in stand.  For measuring the outside temperature, the
thermometer's outdoor sensor cord extends up to 10 feet and is permanently
attached to the thermometer.

When selecting a location for the thermometer or outdoor sensor, consider
the following:

  Do not mount the thermometer or sensor where they will be in direct sun-
  light.

  Keep the thermometer and sensor away from hot and cold sources such as
  stoves, heating and air conditioning vents, and radiators.

  Do not place the thermometer in water or in a location where it is likely
  to get wet. Only the sensor and cord are waterproof.

Mounting the Thermometer

You can mount the thermometer on a clean, dry surface with the adhesive
tape strips on the back of the thermometer or with a screw.

To mount it with the adhesive tape, peel the paper covering from the tape
strips. Then firmly press the thermometer against a smooth surface in the
desired location.

To mount the thermometer with a screw, drive a small screw (not supplied)
into the desired location, then align the keyhole slot on the back of the
thermometer with the screw on the wall, and slide the thermometer down on
the screw until it is secure.

Using the Stand

To place the thermometer on a flat surface, pull the bottom of the built-in
stand away from the back of the thermometer.

Mounting the Outdoor Sensor

Drive a small nail or screw (not supplied) into the desired location, then
route the sensor's cord through a window.  Hang the metal rod's loop on the
nail or screw.

NOTE:  If the loop will not fit over the nail or screw's head, thread the
       nail or screw through the loop before driving it into the wall.


(AV/EB 12/31/96)

Privacy Policy