Metal Detector  (630-3003)        Preparation         Faxback Doc. # 6274

ADJUSTING THE STEM

Follow these steps to adjust the metal detector's stem before use.

1.  Hold the detector with the search coil level to the ground.

Note:  The search coil should be approximately 1/2 to 2 inches above
       the ground.

2.  Turn the stem's lock nut clockwise until it loosens.

3.  Extend the stem to the desired length.

4.  Turn the stem's lock nut counterclockwise to lock it in place.

5.  Wind the search coil cable around the stem.  Be sure to provide
    enough slack in the cable to accommodate angle adjustments.

6.  Place the search coil plug into the plug connection at the base of
    the control housing.  Be sure the holes and pins line up correctly.
    Push the plug in until it is secure.

Caution:  Do not force the plug or you may damage it.

Note:  When disassembly is required, remove the plug by pulling at the
       connection point.

ADJUSTING THE SEARCH COIL

Hold the search coil level with the ground and loosen the knob at the
search coils end.  Adjust the search coil and tighten the knob to keep
the search coil from rotating or wobbling.

You can put the search coil in fresh or saltwater up to 6" from the
control housing.  Rinse it with fresh water afterwards to prevent
corrosion.

ADJUSTING THE METER

The meter is used for three functions:  testing batteries, determining
quality of hidden metal, and tuning the detector.

With the power off, use a thin-blade screwdriver to turn the alignment
control until the pointer lines up with 0 on the scale.

(BR/smc-05/09/94)

Privacy Policy