Radio Controlled Fire Engine
(600-2765)                 Operation                  Faxback Doc. # 56455

Driving the Fire Engine

WARNING:  Never play with the Fire Engine in the street.

Follow these steps to drive the Fire Engine.  For maximum range, hold the 
transmitter with the antenna pointing straight up.

1.  Slide ON/OFF on the Fire Engine to ON.

2.  To have the Fire Engine's siren sound when it is driving forward,
    slide SOUND ON/OFF to ON.

3.  The Fire Engine's transmitter has one control button.  Hold down the
    button to move forward with emergency lights and headlights flashing.

    The Fire Engine stops when you release the button.

    To drive the Fire Engine backward and make it turn, hold down the
    button on the transmitter again.

4.  When you finish playing with the Fire Engine, slide ON/OFF to OFF.

Helpful Hints

If the Fire Engine's motor runs but does not respond to the transmitter, 
move closer to the Fire Engine and try again.

If someone uses a CB nearby, it might interfere with control of the Fire 
Engine.  If this happens, move the Fire Engine away from the CB.

You cannot operate the Fire Engine near devices with transmitters that use 
the same frequency (49 MHz).

If the Fire Engine moves slowly and you have installed fresh batteries, 
check the wheel mechanisms for lint, thread, hair or dust.

(EB 8/18/99)