RC Action Police Car
(600-2753)                 Care and Maintenance       Faxback Doc. # 49208

The following suggestions will help you care for your RadioShack RC-Action
Police Car so you can enjoy it for years.

  Do not use the Police Car on a wet floor or in mud or sand.

  Clean it with a damp cloth to keep it looking new.

  If someone is operating a CB transceiver nearby, it might interfere with
  your control of the Police Car.  If this happens, move your Police Car
  to a new location or wait until the CB stops transmitting.

  Running your Police Car continuously for long periods generates high
  heat levels.  Heat causes wear and tear on the motor.  To help keep heat
  levels down, when your Police Car's battery power dies, let the Police
  Car cool at least 10 minutes before installing new batteries.

Modifying or tampering with the Police Car's internal components can cause
a malfunction and invalidate your Police Car's warranty and void your FCC
authorization to operate it.  If your Police Car is not performing as it
should, take it to your local RadioShack store for assistance.

THE FCC WANTS YOU TO KNOW

Your Police Car might cause TV or radio interference even when it is
operating properly.  To determine whether your Police Car is causing the
interference, turn off your Police Car.  If the interference goes away,
your Police Car is causing it.  Try to eliminate the interference by:

  Moving your Police Car away from the receiver.

  Contacting your local RadioShack store for help.

If you cannot eliminate the interference, the FCC requires that you stop
using your Police Car.

(BR/eb 8/13/98)