RC Action Police Car
(600-2753)                 Batteries                  Faxback Doc. # 49206

INSTALLING BATTERIES

CAUTIONS:  Uses only fresh batteries of the required size and recommended
           type.

           Do not mix old and new batteries, different types of batteries
           (standard, alkaline, or rechargeable), or rechargeable
           batteries of different capacities.

           Never leave dead or weak batteries in the Police Car.

           If you do not plan to use the Police Car for several days,
           remove the batteries.

           Dispose of batteries properly; do not bury or burn them.

Installing the Police Car's Batteries

You need four AA batteries (not supplied) to power the Police Car.  We
recommend alkaline batteries, such as RadioShack Cat. No. 23-552.  Follow
these steps to install the batteries.

1.  Set ON/OFF on the back of the Police Car to OFF.

2.  Use a coin to twist the slot beside the battery compartment cover on
    the bottom of the Police Car.  Then lift up the cover to open it.

    CAUTION:  The battery compartment cover is hinged.  Do not try to
              remove it.

3.  Install the batteries on top of the ribbon, as indicated by the
    polarity symbols (+ and -) marked inside.

4.  Close the cover and make sure it snaps shut.

If the Police Car moves slowly or not at all, gently pull the ribbon to
remove the batteries, then replace them with fresh ones.

Installing the Controller's Battery

You need one 9-volt battery (not supplied) to power the controller.  We
recommend an alkaline battery, such as RadioShack Cat. No. 23-553.

1.  While pressing down on the battery compartment cover, slide it off to
    remove it.

2.  Put the battery in the compartment as indicated by the polarity
    symbols (+ and -) marked inside.

3.  Replace the cover.  Be sure it snaps into place.

If the motor runs, but the Police Car does not respond to the controller,
replace the controller's 9-volt battery.

(BR/eb 8/13/98)